• UR90 & UR91 can be used together on your layout to provide both IR and radio communication at the same time.
• If you have Infra-ready throttles (DT400, DT300 or DT100IR) that came with your starter set, the UR90 is the only thing you have to add to get infra red throttle operation.
• Requires 12 volt power supply such as Digitrax PS12. One PS12 can be used to power up to 6 UR90’s. " >

 Welcome to
  LightHouse Hobbies

Digitrax UR90 Wrlss infra-red rcvr only

• UR90 is an IR receiver that can be added to any LocoNet system.
• Fascia mounted panel
• One RJ12 Throttle jack for plugging in for loco selection and in case of emergency and 2 RJ12 LocoNet jacks in back for connecting to LocoNet and other LocoNet devices.
• Supports approximately 10 IR throttles.
• Most layouts will need more than one UR90 because IR is line of sight and the receivers must be able to "see" the IR signal.
• UR90 & UR91 can be used together on your layout to provide both IR and radio communication at the same time.
• If you have Infra-ready throttles (DT400, DT300 or DT100IR) that came with your starter set, the UR90 is the only thing you have to add to get infra red throttle operation.
• Requires 12 volt power supply such as Digitrax PS12. One PS12 can be used to power up to 6 UR90’s.